1000Base-T SFP Transceiver

1000Base-T SFP Transceiver

Short Description:

The 1000Base-T SFP transceiver is copper SFP module which has one fiber port and one copper port(RJ45).CISCO Compatible.


  • Payment Terms: Paypal,western union,L/C,D/A,D/P,T/T
  • Description

    Specification

    Application

    Order information

    Questions&Comments

    Product Tags

    Description:

    Baudcom’s BDTR-GB-PxRC Copper Small Form Pluggable (SFP)transceivers is high performance, cost effective module compliant with the Gigabit Ethernet and 1000- BASE-T standards as specified in IEEE 802. 3-2002 and IEEE 802.3ab, which supp- orting 1000Mbps data- rate up to 100 meters reach over unshielded twisted-pair category 5 cable. The module supports1000 Mbps full duplex data-links with 5-level Pulse Amplitude Modulation (PAM) signals. All four pairs in the cable are used with symbol rate at 250Mbps on each pair. The module provides standard serial ID information compliant with SFP MSA, which can be accessed with address of A0h via the 2wire serial CMOS EEPROM protocol. The physical IC can also be accessed via 2wire serial bus at address A0h.

    Features:

    • Up to 1.25Gbps bi-direction data links
    • 100m transmission over unshielded twistedpair (UTP) Category 5 Cable
    • Support intelligent auto-negotiation 1000BASE-T operation in host systems with
    • SGMII interface
    • Hot-pluggable capability
    • SFP/GBIC form with compact RJ-45 connector
    • Very low EMI and excellent ESD protection
    • +3.3/5V Single power supply
    Interface:
    All high-speed signals are AC-coupled internally.
    Table 3. High-speed electrical interface, transmission line-GBIC
    High-Speed Electrical Interface Transmission Line-GBIC
    Parameter
    Symbol
    Min
    Typ
    Max
    Units
    Notes/Conditions
    Line Frequency
    fL
    125
    MHz
    5-level encoding, per IEEE 802.3
    Tx Output Impedance
    Zout,TX
    100
    Ohm
    Differential, for all Frequencies between 1MHz and 125MHz
    Rx Input Impedance
    Zin,RX
    100
    Ohm
    Differential, for all Frequencies between 1MHz and 125MHz

     

    High-speed electrical interface, host-GBIC
    Table 4. High-speed electrical interface, host-GBIC
    High-Speed Electrical Interface, Host-GBIC
    Parameter
    Symbol
    Min
    Typ
    Max
    Units
    Notes/Conditions
    Single ended data input swing
    Vinsing
    250
    1200
    mV
    Single ended
    Single ended data output swing
    Voutsing
    350
    800
    mV
    Single ended
    Rise/Fall Time
    Tr,Tf
    175
    psec
    20%-80%
    Tx Input Impedance
    Zin
    50
    Ohm
    Single ended
    Rx Output Impedance
    Zout
    50
    Ohm
    Single ended

     

    General Specifications
    Table 5. General specifications
    General
    Parameter
    Symbol
    Min
    Typ
    Max
    Units
    Notes/Conditions
    Data Rate
    BR
    10
    1,000
    Mb/sec
    IEEE 802.3 compatible.
    See Notes 2 through 4 below
    Cable Length
    L
    100
    m
    Category 5 UTP. BER <10-12

     

    Notes:
    1. Clock tolerance is +/- 50 ppm
    2. By default, the BDTR-GB-P is a full duplex device in preferred master mode
    3. Automatic crossover detection is enabled. External crossover cable is not required
    4. 1000 BASE-T operation requires the host system to have an SGMII interface with no clocks, and the module PHY to be configured per Application Note AN-2036. With a SERDES that does not support SGMII, the module will operate at 1000BASE-T only.
    Environmental Specifications
    Table 6. Environmental specifications
    Environmental Specifications
    Parameter
    Symbol
    Min
    Typ
    Max
    Units
    Notes/Conditions
    Operating Temperature
    Top
    0
    85
    °C
    Case temperature
    Storage Temperature
    Tsto
    -40
    85
    °C
    Ambient temperature

    Application:

    • LAN 1000Base-T
    • Switch to Switch interface
    • Switched backplane applications
    • Router/Server interface
    BDTR-GB-P1RC 10/100/1000Mbps, SGMII interface, Copper SFP with spring latch   Request price
    BDTR-GB-P3RC 1000Mbps only, SERDES interface, Copper SFP with spring latch   Request price

    INQUIRY NOW
    • * CAPTCHA: Please select the Flag

    Related Products

    INQUIRY NOW
    • * CAPTCHA: Please select the House