4/8*Voice over Ethernet(IP)

Description

The converter encapsulates the voice data in the IP packet, supports the UDP packet mode, realizes the 1-8 voice service to the 100M Ethernet conversion, in the same network segment or through the router to achieve different network segment communication.

• High transmit efficiency, low transmit delay.
• Provide Console(CLI)/WEB management interface, easy to install and open;
• Voice port to support FXO/FXS/2-4 Wire E&M / 2-4 wire Audio/Magnet phone interface, FXO port plug into PBX, FXS port is connected to the user’s telephone;
• Voice FXO / FXS interface, support for caller ID / reverse polarity billing / fax function;
• Both sides of the device support FXO+FXS hybrid access;
• Ethernet interface rate of 10M / 100M, full duplex / half duplex adaptive;
• Support power failure or automatic network recovery;
• Support Ethernet packet out-of-order recovery and cache to anti-network delay;
• Adjustable frame length to balance bandwidth and transmission delay;
• Based on hardware design, start fast;
• DC-48V / DC24V power supply with polarity automatic detection function;installation does not need to distinguish between positive and negative;

• Ethernet interface(10/100M)
• Interface rate:                         10/100 Mbps, half/full duplex auto-negotiationInterface Standard:               Compatible with IEEE 802.3, IEEE 802.1Q (VLAN)

  MAC Address Capability:     4096

  Connector:                             RJ45, support Auto-MDIX

• FXS Phone Interface

Ring voltage:                              75V

Ring frequency:                         25HZ

Two-line Impedance:                 600 Ohm (pick up)

Return loss:                                40 dB

• FXO Switch Interface

Ring detect voltage:                   35V

Ring detection frequency:        17HZ-60HZ

Two-line Impedance:                 600 Ohm (pick up)

Return loss:                                40 dB

• EM 2/4 Line

AD:                                                0dB

DA:                                               0dB

Two/Four-line Impedance:              600 Ohm

Return loss:                                20 dB

• Working environment

Working temperature:           -10°C ~ 50°C

Working Humidity:                5%~95 % (no condensation)

Storage temperature:                   -40°C ~ 80°C

Storage Humidity:                        5%~95 % (no condensation)