EOC All-In-One (ONU+OR+2*EOC)
Short Description:
Product Overview BD-2EOC-OR-ONU is an all-in-one EOC Master with EOC master module, ONU module and …Description
Specification
Application
Order information
Q&A
Product Tags
Reviews
Description
Product Overview
BD-2EOC-OR-ONU is an all-in-one EOC Master with EOC master module, ONU module and OR module.
We can use one BD-2EOC-OR-ONU to instead of three type products, HFC optical node, EPON ONU and EOC mater. It can reduce the number of active node in the system, decreasing failure rate and saving a space. It is the best choice of CATV, Internet and VOD for the operator.
The EOC Master Module in the BD-2EOC-OR-ONU is based the Qualcomm AR7410 chipset solution，with high anti jamming capability OFDM technology. The 7.5-65MHz low frequency band is used for EOC signals. Built in high isolation filter as CATV RF and EOC signal mixer, the EOC signal and CATV signal in 87~862MHz can run on one cable without interference. The EOC Master can provide high speed data service. The PHY Layer speed is 600Mbps, the MAC Layer throughput is up to 320Mpbs.
The OR module in the BD-2EOC-OR-ONU can provide an HFC optical input and one RF output. The CATV signal will convert from optical to RF signal here. The OR module is a high quality optical receiver product. It received the optical signal from the TX of HFC network, and the signal processed by the PIN, Amplifier, EQ and AGC to a stable RF output. The output level will be up to 108dBuv.
The ONU module in the BD-2EOC-OR-ONU designed with one EPON port, two standard 10/100/1000 Base-TX Ethernet ports. It provides the key functionality of 802.3ah EPON ONU. By using the EPON technology, the ONU module provides a high-speed data channel through a single optical fiber with a rate of 1.25 Gbit/s on bi-direction. In addition, it offers the QOS, flexible bandwidth allocated to provide quality high-speed data service, voice service, and video service.
Function Features
n High integration with two EOC Master modules, one ONU module and one OR module
n Aluminum alloy die casting shaping, good heat dissipation
n Outdoor waterproof designed, 60V/220V power supply optional
n 7.5-65Mhz frequency for EOC signals., no influence on CATV Service
n Support data encryption
n Support broadcast storm limitation
n Support data packet statistics
n Support auto-update and auto-configuration
n Support the optical power monitor
n Flexible bandwidth allocation function
n Support various QOS service level
n EMS network management based on SNMP
n Provide a rich fault alarm function, easy to fault diagnosis
n Support software online upgrade
n OR support AGC
n CATV RF output up to 108dBuv
n ONU module compliant with IEEE802.3ah and CTC2.1standards.
n ONU module provides tow auto-negotiation GE ports
n ONU module support interconnection with the third-party OLT
n Support the EMS network based on SNMP
Specification
| Item | Parameters | Specification |
| Specification of EOC Module | ||
| Interface and LED Indicator | RF Port | One TV (CATV Signal) Output, metric F-Female
One CABLE (Mixed Signal) Input, metric F-Female |
| Ethernet Port | Two 10/100/1000Mauto-negotiation, RJ45 | |
| LED Indicator | 1 for Power Supply Status
1 CABLE Link Status indicator 2 for Ethernet Ports Status |
|
| Performance Parameters | RF Parameters | Frequency Band :7.5-65MHz
RF Output Level:110±5dBuv@ output of moduleReceive sensitivity: 45dBuv Return Loss:>16dB Output Resistance:75Ω |
| Transmission | PHY Layer:600Mbps
Throughput on MAC Layer:320Mbps |
|
| Modulation Mode | OFDM~ 2690~carriers 4096,1024,256,64,16,8~QAM, QPSK, BPSK, ROBO | |
| Working Mode | TDMA/CSMA | |
| Encryption Mode | AES-128 | |
| Standard | EOC Standard | IEEE P1901(Draft)
HomePlug AV |
| Ethernet Standard | IEEE 802.3, IEEE 802.3x, IEEE 802.3u
IEEE802.1P, IEEE802.1Q |
|
| Software | Network Management | WEB, CLI, SNMP |
| Software Features | VLAN, QOS, Bandwidth Control, Broadcast storm limitation | |
| Specification of OR | ||
| Optical Specifications | Wavelength | 1100～1600 nm |
| Optical Power Input Range | -8～+2 dBm | |
| Recommend optical Power Input Range | -6～0 dBm | |
| Optical Input Return Loss | ≥45 dB | |
| RF Specifications | Bandwidth | 45～870 MHz |
| Flatness | ≤±0.75 dB | |
| Stability of RF output under Operating Temperature | ≤5 dB | |
| Nominal RF Output Level | 108 dBuV | |
| Impedance | 75 Ohm | |
| Return Loss | ≥14 dB | |
| CNR | ≥51 dB | |
| CSO | ≥60 dBc | |
| CTB | ≥65 dBc | |
| Power consumption | <7.5 W | |
| Optical and temperature AGC | Stability of RF output under optical AGC | ≤±1 dB |
| AGC Scope | -6～0dBm | |
| LED Indicator | Indicator Description | RUN: module operating
RF: RF signal PWR：Power is coming up OPTH: Optical power is higher OPTM: Optical power is nominal OPTL: Optical power is lower |
| Specification of ONU Module | ||
| Interface | PON Interface | One EPON port
Meet 1000BASE-PX20 standard Up to 1.25Gbps Upstream and Down-stream SC Connector Single-mode fiber, single-strand Maximum split ratio 1:64 Up to 20Km distance @ 1:32 |
| Ethernet Interface | Two 10/100/1000Mauto-negotiation
Full/Half-Duplex RJ45 type connector , Auto MDI/MDI-X Up to 100m distance |
|
| Performance Parameters | PON Optical Parameters | Wavelength: Upsteam1310nm, Downstream 1490nm
Transmitter Optical Power: -1～4dBm Optical Receive Sensitivity: -27dBm Saturation Optical Power：-3dBm |
| Data Transfer Parameters | Data Transfer Rate: Upstream 900Mbps；Downstream 950Mbps
LAN Interface: 1000Mbps Packet Loss：<1*10E-12 latency：<1.5ms |
|
| Business Capability | Layer 2 wire speed switching
Support VLAN TAG/UNTAG，VLANconversion Support Port-based speed limitation Support Priority classification Support storm control of broadcast |
|
| Network Management | Management Mode | Support IEEE802.3 QAM, ONU can be remotely managed by OLT
Support Remote management through SNMP and Telnet Local management |
| Function | Status monitor, Configuration management, Alarm management, Log management | |
| Indicator | Indicator Description | PWR: Power up or down
LOS: Optical Link Status PON：ONU registered LNK: Link Status |
| Physical Features | ||
| Physical Features | Power supply & Consumption | Power Supply：220V/60V optional
Consumption：<24.5W |
| Size & Net weight | Dimension：290×220×120mm
Weight：3.7kg |
|
| Environment Attribute | Working Temperature：－10～65℃
Storage Temperature：-40～85℃ Working humidity：10%～90%non-condensing Storage humidity：10%～90% non-condensing |
|
Typical Application
- CATV
- Internet Access
- VOD
- IPTV
- Camera monitor system
Specification
Application
Figure 1 BD-2EOC-OR-ONU Application Illustration
Order information
| Product Model | Descriptions | Inquiry |
|---|---|---|
| BD-4EOC-OR-ONU /220VAC | Built-in one ONU Module, one OR module and two 74 series chipset EOC Modules；One EPON uplink port, one CATV optical input, four TV+data mixed output port. Outdoor waterproof designed. 220VAC power supply. | Request Price |
| BD-4EOC-OR-ONU /60VAC | Built-in one ONU Module, one OR module and two 74 series chipset EOC Modules；One EPON uplink port, one CATV optical input, four TV+data mixed output port. Outdoor waterproof designed.60VAC power supply. | Request Price |
| BD-2EOC-OR-ONU /220VAC | Built-in one ONU Module, one OR module and two 74 series chipset EOC Modules；One EPON uplink port, one CATV optical input, two TV+data mixed output port. Outdoor waterproof designed. 220VAC power supply. | Request Price |
| BD-2EOC-OR-ONU /60VAC | Built-in one ONU Module, one OR module and two 74 series chipset EOC Modules；One EPON uplink port, one CATV optical input, two TV+data mixed output port. Outdoor waterproof designed.60VAC power supply. | Request Price |
Q&A
Product Tags
Reviews
0 reviews
5
